Main > Main Forum
Home made Starwars yoke for the technically challenged - talk me out of it!!!
PL1:
--- Quote from: BazookaJo on May 16, 2013, 11:48:33 am ---*Of course the sizes required never available in black...
--- End quote ---
Rit Dye should take care of that. ;D
Scott
Generic Eric:
Go for it! Don't forget that prototyping is expensive work.
BadMouth:
--- Quote from: Generic Eric on May 16, 2013, 03:12:18 pm ---Go for it! Don't forget that prototyping is expensive work.
--- End quote ---
The game is that you spend $50 to find $10 worth of parts that work and then brag about building it for $10 worth of parts. ;D
1500points:
interesting. I put some thought into this type of project some time back, then put it off.
Then was given a real SW yoke that needs restoration.
Figured that was easy enough....
BUT now I can't find anyone that sells resto parts of than Ram controls who the concensus says is not an honest seller.
So I've put that on the backburner, too. very interesting predicament.
Curious to see if you come up with a valid solution.
PL1:
--- Quote from: 1500points on May 16, 2013, 04:08:12 pm ---I can't find anyone that sells resto parts
--- End quote ---
Stephen (Mylstar on KLOV) has lots of SW yoke parts at ArcadeFixit and several parts not listed on the site.
If you don't see what you are looking for, drop him a PM or ask me about alternate sources.
Scott
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version