Main > Main Forum

Help with 360 wheel encoder to UHID

<< < (4/5) > >>

MartinJames:
Its not I've configured 2 other pins from the J4 block. one for gnd and one for 5v as per picture.

And to think I thought this was goign to be the easy part!

MartinJames:

--- Quote from: PL1 on April 24, 2013, 02:29:54 pm ---
--- Quote from: vtivti on April 24, 2013, 02:08:48 pm ---Bottom right of the photo? Is that not right?

--- End quote ---

One pin *looked* orange at first, but it is yellow (quadrature) with a red outline (selected pin).

The selected pin settings appear to be right.

Is the other quadrature pin (6?) configured the same? (Mouse, X)

Have you tried reprogramming the board?


Scott

--- End quote ---

Yes but ticked reverse.

BadMouth:
I was just thinking along the same lines (because I've run out of other ideas)

You need to have 2 pins configured as x-axis and in mouse mode.
They must both be connected to the encoder at the same time or it isn't going to do anything.

MartinJames:
As replied above. It does it automatically. Striking either pin to ground affects the mouse cursor. just doesn nothing on the encoder. bloody thing

BadMouth:
Just to humor us, do a screen grab with the other quadrature pin highlighted.

If nothing comes of that, time to email Andy at Ultimarc if he doesn't show up in this thread.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version