Main > Main Forum
LED-Wiz / EZ-Lights Wire Harness and a Newb
rcosner:
Ok, I think I get it. I'm only going to be lighting about 14-18 buttons so it should be ok. Is there anywhere to buy the correct wires premade or am I going to have to make them myself? I see what you mean about the harness wires, I guess it kind of defeats the purpose of the LED-WIZ board.
PL1:
--- Quote from: matsadona on April 05, 2013, 09:51:53 am ---And remember that USB can only provide 500mA in total.
--- End quote ---
Minor clarification: USB spec says that a powered USB hub port can provide 500mA.
If you are using an unpowered hub port, that it is limited to 100mA, though many hubs can exceed that spec.
Scott
Worthing Gooners:
There is no way on earth that i could work this out for myself but here goes a question.
Is it possible that for each individual game the buttons that you can use for that game light up & the ones that are not used stay unlit?
For example you are not scrambling around trying to find the "smartbomb" button in defender amongst a group of 6 buttons?
( If this has already been done i can only apologise at my noob status ignorance..... :blowup:)
shponglefan:
--- Quote from: Worthing Gooners on April 07, 2013, 12:47:57 pm ---There is no way on earth that i could work this out for myself but here goes a question.
Is it possible that for each individual game the buttons that you can use for that game light up & the ones that are not used stay unlit?
For example you are not scrambling around trying to find the "smartbomb" button in defender amongst a group of 6 buttons?
( If this has already been done i can only apologise at my noob status ignorance..... )
--- End quote ---
I believe LEDBlinky software does this (disclaimer: I haven't actually used it myself).
yaksplat:
LEDblinky does this very well. And if the buttons have RGB led's then they will light up to the original colors that were on the games. For example, 1943 will light up two buttons, red and blue.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version