Main > Main Forum

Question Regarding Ipac 4

<< < (2/3) > >>

Yourname942:
where are Tools and test mode again? -.-

Yourname942:
when i try to configure player 3's joystick it sets up as up arrow down as down arrow, left as left, and right as right.
the only problem is player 1 does the same.. so idk what to do. (bc as it is right now, player 1+3 have the same joystick inputs, and player 2+3 share the same inputs)

PL1:
Launch WinIPAC - Pull-down-menus at top, click on "Tools", then on the top option "Test Mode".


Scott

EDIT: I'm running an earlier version of WinIPAC.  See below.

Yourname942:
I don't see that..

This is what winipac looks to me:

http://www.ultimarc.com/images/wip_main.jpg


the version i have is 1.0.16 winipac. (also players 3+4 are not greyed out like in the above picture.

PL1:
BINGO!!

That's the "legacy" version for pre-2004 IPac's.

I assume yours isn't that old.

Try downloading the newer version of WinIPAC here.




Scott

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version