Main > Main Forum
Help needed! Changing angle of control panel
Richardgregory:
Thanks for all the feedback: well, I suppose it isn't bad I don't think if I'm sitting down - the angle isn't that a bothersome.
I might at some point attempt to redo it.
Typefighter01/all: Good suggestion. If I rebuild the CP and level it off, I will probably need to cut out some of the front wood of the cabinet so that I can sink in the control panel as shown in below's image.
Unless I leave everything as is and try and redo the monitor position(remove some wood) so that I will have room to angle down the existing CP.
P.S. Hmm, the frontal shot doesn't make it seem so bad of an angle...maybe I should just leave everything as is :)
Gray_Area:
It depends on your hand placement. If you tend to set your wrist down, and you're standing at that machine, you'll have trouble. My main rig is right behind me. It has a frankenpanel, and is at the same level as my desk, so I set half my forearm on it and I'm totally comfortable. My candy has a short and flat cp, and I find I have to hold my wrist up in games where I'm doing a lot of firing.
Navigation
[0] Message Index
[*] Previous page
Go to full version