Main > Retail vendors
CNC Cut Bartop Kits - Orders Open! New Models Available!
HaRuMaN:
--- Quote from: SNAAKE on March 07, 2013, 12:25:46 am ---whatever happened my idea for using the asus 23" evo monitor? can you make one to fit that monitor? you'd get lot more sales from srk too(can only guess). I am buying one if you can.
--- End quote ---
I will look into that.
HaRuMaN:
--- Quote from: rablack97 on March 06, 2013, 08:36:48 pm ---Haruman,
Question on your melamine, is there any reason you went with the particle board?
I've sourced some 3/4 melamine with the MDF core. It's not available in 5/8 though...
Was it weight?
--- End quote ---
I'm using 1/2" for these kits, as far as I know, the melamine coated particle board is the only material available in the side.
The CNC cuts are razor sharp, though.
ArcadeNerd:
I've got enough parts sitting around to throw a little something together and these look pretty nice. I'll give one a shot :)
HaRuMaN:
--- Quote from: ArcadeNerd on March 08, 2013, 12:56:13 am ---I've got enough parts sitting around to throw a little something together and these look pretty nice. I'll give one a shot :)
--- End quote ---
Invoice sent, thanks!
HaRuMaN:
--- Quote from: SNAAKE on March 07, 2013, 12:25:46 am ---whatever happened my idea for using the asus 23" evo monitor? can you make one to fit that monitor? you'd get lot more sales from srk too(can only guess). I am buying one if you can.
--- End quote ---
Hey, get me some dimensions and I will work on it for you.
Amazon says it is:
21.6" x 13.8"
Newegg says it is:
21.61" x 16.1"
Let me know depth, too...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version