Main > Retail vendors
CNC Cut Bartop Kits - Orders Open! New Models Available!
CWorley:
--- Quote from: HaRuMaN on March 02, 2013, 09:40:15 am ---If you can get me some width, height, and depth dimensions, I can check.
Sent from my GT-P3113 using Tapatalk 2
--- End quote ---
Sure. The dimensions are 17 5/8" x 13 7/8" x 3" (WxHxD).
Thanks!
HaRuMaN:
--- Quote from: CWorley on March 03, 2013, 11:25:01 am ---
--- Quote from: HaRuMaN on March 02, 2013, 09:40:15 am ---If you can get me some width, height, and depth dimensions, I can check.
Sent from my GT-P3113 using Tapatalk 2
--- End quote ---
Sure. The dimensions are 17 5/8" x 13 7/8" x 3" (WxHxD).
Thanks!
--- End quote ---
Width wise it fits, barely. 17.72" available. Height, you could may get away with it, you may have to shorten up the CP a bit...
Depth might work. At the edge, you have 1.5" between the speaker panel and the baton for back piece...
Decasing might help, too.
Malenko:
or dremel the sides.
HaRuMaN:
Ok, let's go ahead an open this up for orders. I'll keep the window open a couple of weeks, or until I get 10 orders, whichever happens first.
Continental US only for now.
Send me a PM with the following information:
Quantity:
Slot cut (Y/N):
Marquee / Bezel polycarbonate included (Y/N):
Blank or drilled CP and Admin panel:
Email address:
Shipping address:
And I will send you a PayPal money request with the details.
Payment will be required up front, as these are cut to order. I will update this thread with all details as they update.
HaRuMaN:
3 / 10 orders taken, 7 slots left. :applaud:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version