Main > Retail vendors
CNC Cut Bartop Kits - Orders Open! New Models Available!
HaRuMaN:
--- Quote from: Ginsu Victim on February 21, 2013, 09:45:50 pm ---You planning on doing this for a while? I may not be able to place an order until August or September.
--- End quote ---
Yeah, my CNC guy is fine with smaller runs, too. As long as he doesn't close up shop (which it doesn't look like he will, he's always busy), I should still be doing this.
jammin0:
These look sweet. So . . . batons on the CP, and have you done the VESA mount yet? I'm assuming you would screw in batons and then glue to that?
I can't wait to see people start making these. I might have to order one or two when I sell something to generate some cash. Love the finish.
HaRuMaN:
--- Quote from: jammin0 on February 22, 2013, 03:37:26 pm ---These look sweet. So . . . batons on the CP, and have you done the VESA mount yet? I'm assuming you would screw in batons and then glue to that?
I can't wait to see people start making these. I might have to order one or two when I sell something to generate some cash. Love the finish.
--- End quote ---
There are fatter batons for the monitor mount. It's up to the user on where to mount it (due to varying monitor sizes, etc). I forgot to show the batons in the first set of pics, I'll through them up later.
bamaholic:
I'm going to jump on the bandwagon and say this kit looks awesome. I'm always looking for a new project and this may be it.
Goz:
I can post a pic of my mostly assembled V1 I am planning on wiring controls tomorrow and setting some more of it up.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version