Software Support > GroovyMAME

OSD video modes and HyperSpin

<< < (2/3) > >>

Calamity:
Hi Sledge,

Make sure you're using the last version of VMMaker (1.3c).

Sledge:
Yup, i am...
Just downloaded again before i tried using the magic resolutions with hyperspin..

Calamity:

--- Quote from: mamenewb100 on October 16, 2012, 10:45:03 pm ---I'm thinking since the Vertical frequency is so low that it is able to display with a high Horizontal frequency. It is displaying at 37 Khz, which is within the 30-40 range of the monitor.

--- End quote ---

That's it. Refreshing at 50 Hz allows it to keep below the 40 kHz limit, so for the monitor this video mode is just fine. Monitors care about frequecies, not resolutions. But since most people don't understand the limits expressed in kHz, a typical max resolution is advertised too, which only makes sense if you also state the vertical frequency, and can be misleading, e.g.  800x600 at 75 Hz, would be out of your monitor's range.

Calamity:

--- Quote from: Sledge on October 17, 2012, 05:46:59 am ---Yup, i am...
Just downloaded again before i tried using the magic resolutions with hyperspin..

--- End quote ---

Could you attach your vmmaker.ini here for me to have a look?

Sledge:
Here you go :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page