Main > Main Forum
Recoil Kit now available for Aimtrak Gun
8BitMonk:
I've updated my post on the Hyperspin board with a sample of a 36v power supply. It's noticeably better than the 20v or 24v and by far my favorite. I would say no to using a 20v power supply, 24v is passable and 36v is preferable.
http://www.hyperspin-fe.com/forum/showthread.php?20938-Aimtrak-diy-recoil-kit-released!!/page4
The 36v supplies I got were the Kodak ones on referred to on ebay (url earlier in thread) and were only about $10 apiece.
AndyWarne:
--- Quote from: 8BitMonk on October 23, 2012, 10:22:29 am ---
Why does the documentation say 'peak current of 5amps'?
--- End quote ---
Because the 5 amps is only required in short 40 millisecond bursts, so there is no need for a supply which has a continuous rating of 5 amps. A peak rating of 5 amps is sufficient.
rcub3:
Did we ever get an asnwer on what is needed if you are starting from zero? Gun Kit, recoil kit, and new housing?
nick3092:
--- Quote from: rcub3 on November 15, 2012, 04:44:43 pm ---Did we ever get an asnwer on what is needed if you are starting from zero? Gun Kit, recoil kit, and new housing?
--- End quote ---
I answered it earlier in the thread after I emailed Andy. The shells are just that. No trigger, side button, screws, etc. So you need the full gun kit as well as the new shells and recoil kit.
rcub3:
I'm assuming each solenoid will need it's own power supply, right?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version