Main > Main Forum
Cocktail cabinet with trackball and spinner control panels???
(1/1)
cmoses:
I just recently acquired a cocktail cabinet that I will be turning into a MAME cabinet. I thought I had seen a cocktail cabinet recently that had 1 joystick, 3 buttons and a trackball one on side and 1 joystick, 3 buttons and a spinner on the other side. I did a bunch of searching but have not been able to find it. Does anyone know if the cocktail cabinet I am referring to?
PL1:
Sounds like Millercentral's 3-sided cocktail.
Panel pics in this thread.
Scott
cmoses:
No that was not it. It was only 2 sided. As I recall one side had red joystick and buttons. The other side was blue. Joysticks on left, buttons in middle, trackball or spinner on the right.
wxforecaster:
I'd be curious to see this as well. Looking at my Midway cocktail at least, I just don't see a way to make it fit given the real-estate taken up by a joystick and trackball. I figure someday I'll own a millipede/centipede and marble madness and I'll be good :)
cmoses:
So I finally found it. It wasn't a project but a cocktail table by Monster Arcade. You can see it here.
Still like the idea. I wonder if it could be done on a Midway/Namco cocktail cabinet. I have 11" wide control panels. I bet you could get a 8 way joystick 3 buttons and a 2 1/4 in trackball on there.
Then the same except a spinner instead if the trackball on the other side.
Anyone out there done this?
Navigation
[0] Message Index
Go to full version