Software Support > GroovyMAME
H9110 issues
Podbod:
I'm already using a dvi-vga converter (As otherwise how would I be getting the input to the jpac. Or are you suggesting that the converter I'm using might not be fully compatable etc?) but acutally that got me thinking about the fact that theres two dvi outs on the back of the card. Didn't occur to me at the time that it might be swapping over the output when it reaches windows (dunno why but its plausable right?)
That might explain why swapping to the PC crt also doesnt show anything.
The the PC pnp monitor in from boot it might recognise its that port and then keep it set. Meaning I can swap over to the arcade monitor fine.
Cheers again for the reply. Nice to know I;m making some progress at least :D
Pod
krick:
*usually* the port you need to plug into the JPAC is the one on the "bottom" of the card, that is, the one that's closest to your motherboard.
Typically, the installation procedure would go something like this...
Start with PC hooked up to "normal" monitor on primary DVI port.
Set desktop resolution to 640x480.
Uninstall standard ATI Catalyst drivers.
Run Catalyst Cleaner ( http://www.ultimarc.com/cat-uninstaller.exe ).
Install CRT_EmuDriver.
Shut down PC, disconnect "normal" monitor, attach arcade monitor to primary DVI port using dongle.
Boot up PC to 640x480 interlaced desktop on arcade monitor.
Configure and run VMMaker to generate optimal resolutions.
Profit.
I seem to recall reading about someone having issues when they were switching back and forth between a normal and arcade monitor and/or having them both connected at the same time. I think it might have had something to do with the EDID plug and play stuff in the normal monitor.
Podbod:
That settles it then as I had it in the top port! :) That means that apart from the v-pos issue I think its all sorted.
I'm getting married tomorrow tho so I wont be able to play with it again for at least a month. I'll repost in the monitor section then to confirm if its a cap kit job
Cheers once again for all your help guys.
Pod
krick:
--- Quote from: Podbod on September 07, 2012, 04:52:01 pm ---
I'm getting married tomorrow tho so I wont be able to play with it again for at least a month.
--- End quote ---
LOL. Unintentionally funny on so many levels.
Congratulations. :cheers:
Calamity:
Congratulations Pod!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version