Main > Main Forum
RGB 3 Way Cocktail - Need Opinions -
iserian:
These cost $270 bucks?
1 269.33000 269.33 ?
--- Quote from: Unstupid on September 05, 2012, 12:21:15 am ---This one works well too:
http://www.digikey.com/product-detail/en/0638191300/WM9025-ND/1873803
--- End quote ---
Unstupid:
My bad.... Are you building this with a budget? ???
PL1:
Iserian - Put "crimp ratchet" into the forum search to get about 8 threads of info and links that won't bust your budget.
Scott
Nephasth:
--- Quote from: paigeoliver on September 04, 2012, 11:30:17 pm ---
--- Quote from: iserian on September 04, 2012, 07:01:32 pm ---How about this?
--- End quote ---
Been using something like that for years, no complaints.
--- End quote ---
You've been using crush type crimpers for these types of terminal pins?
...and have no complaints? You're full of ---steaming pile of meadow muffin---.
On a side note; iserian, you can get a set of the crimpers I pictured earlier for $20-$30 that come with the dies to crimp the "standard" Molex pins found in arcade cabs and buy the set of dies in the picture for smaller terminal pins (Micro-Fit) for about $7 shipped.
millercentral:
I got one like this off ebay:
And I went from 15 minutes-per unreliable crimp (and a lot of swearing), to 3 or 4 crimps a minute with extremely high reliability. It holds the terminal in place with a little spring loaded clamp, you just insert the wire, and both crimp areas are compressed in one squeeze. Mine came with a Micro-Fit style die (like in the picture), which works well enough for both the wire-to-wire connections and the pins needed for the wire-to-board connectors as well.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version