Jennifers "HOT" new pin....

Arcade Collecting > Pinball

<< < (28/34) > >>

jennifer:

--- Quote from: Malenko on October 31, 2018, 08:44:37 pm ---I guess we're friends cause Ive been following along from the start.

--- End quote ---
Yes you are (*Smooch, wink ;)) And you have been quite patient, So the update for you... Jenns workbench needed some upgrades So I got a variable AC supply (to finish the bench test), IDC connector squeezer guns and dies (.156, and .100) and a few other odds and ends. Currently in the process of sourcing the wire and connectors for the new harness. The lamps on the backboard were IDC, but Given that is a moving door it seems solder terminals would be better, So while making that light board Jenn made 2, One to be modified a little for a better fit for the LCD, and covered on the backside with #8 mirror grade stainless, and possibly some Led flasher strips (not bulbs) behind the helicopters and police cars. although still bench testing the idea and need to the to shut them down via relay in the event of a "tilt" and the other to be a original duplicate....However, after drying one warped some and the duplicate is off the table.

lilshawn:
this whole ride has been fun. :applaud:

jennifer:

--- Quote from: lilshawn on November 02, 2018, 10:26:28 pm ---this whole ride has been fun. :applaud:

--- End quote ---
I am happy you would think so, there is so much that hasn't been documented but Jenn does try to hit the fun parts...The last piece of platting came back, (the circuit board panel) done up with zink chromate, I haven't seen it yet and really have high hopes cause that thing was nasty black and slimy. But just for you Jenn will do an unboxing check it out pic 8)

jennifer:
Problems loading pics....

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version