Main > Main Forum
How to power this. And powering a MAME cabinet.
mcseforsale:
Build yer own. I copied it from Yaksplat's idea. Here's a link to my build thread:
http://forum.arcadecontrols.com/index.php?topic=117977.msg1267034#msg1267034
AJ
TJCOMBO:
I am still very new to this and my electrical wiring experience is limited, but you have to start somewhere. :shrug: Ended up reading the manual online, didn't think about that. It all came together and makes sense. MonMotha, yes, you were correct. I assume I would just run a 18 ga wire from that first pin -5VA on that connector in the pic to a +5VA pin on the molex connector of the computer PSU. Is that right?
Powerstrip seems like a great solution.
It would be nice to wire the ON/OFF switch on top of the cabinet to a power strip or to the computer and plug the computer
matsadona:
--- Quote from: TJCOMBO on July 11, 2012, 03:32:17 pm ---I assume I would just run a 18 ga wire from that first pin -5VA on that connector in the pic to a +5VA pin on the molex connector of the computer PSU.
--- End quote ---
That would give you 10 volts. Not a good idea if you have a 5V bulb... Or maybe I just got you wrong in some way.
yaksplat:
--- Quote from: mcseforsale on July 11, 2012, 02:49:27 pm ---Build yer own. I copied it from Yaksplat's idea. Here's a link to my build thread:
http://forum.arcadecontrols.com/index.php?topic=117977.msg1267034#msg1267034
AJ
--- End quote ---
I approve of this :)
http://yaksplat.wordpress.com/2011/10/27/wiring-up-the-main-power-switch/
http://yaksplat.wordpress.com/2011/11/21/main-power-switch-wiring-part-2/
http://yaksplat.wordpress.com/2011/10/27/wiring-in-the-relay/
Navigation
[0] Message Index
[*] Previous page
Go to full version