Main > Main Forum

Zero Delay Board and UHID. M2 cant do both? *Solved*

<< < (2/2)

BadMouth:
Model 2 emulator should be seeing both controllers and allow you to use both without any workarounds.
I'm using a logitech wheel and an act labs shifter.  They show up as separate controllers.

Make sure both are plugged in before launching the emulator.
For the analogue controls, you have to double click on the input on the config controls tab,
then another window will pop up that allows you to select the device and axis.

The rest of the controls will just automatically map to whichever controller you move after you double click it to map.

In addition to the wheel and shifter, I'm also using a Key-Wiz because a lot of the older driving games limit you to one controller and a keyboard.  Having buttons post as arrow keys, enter and escape also makes navigating menus of pc games easier.

mrcram:
Ok, so I figured it out but it was a pain.  I am running XP by the way.  So to start, I have to unplug both boards (UHID and zero delay KBE)  I then plugged in zero delay board first and changed button settings in M2.  I then plugged in UHID and changed steering/accel/brake to UHID.  Works perfect now.  I am not sure why it only works this way for me.  Maybe my computer?  Before everytime I tried to change anything in M2 config, it would automatically put in Joystick #2 up.  Weird how the littlest change makes a difference.  

RamjetR:
I have to do this too. Sometimes M2E crashes when I have to configure an input and have more than 2 usb game devices installed.

I have a USB Dual Gamepad (hacked for VR buttons + Sequential shifter right hand side)
Logitech G27 (Wheel, Pedals and Gears 6speed)
USB Gamepad adaptor (Coin slots)

So I just unplug them all but the one I need to configure, then plug the rest back in. You only have to do it the first time you configure it.

AndyWarne:

--- Quote from: mrcram on June 25, 2012, 12:23:38 am ---Ok, so I figured it out but it was a pain.  I am running XP by the way.  So to start, I have to unplug both boards (UHID and zero delay KBE)  I then plugged in zero delay board first and changed button settings in M2.  I then plugged in UHID and changed steering/accel/brake to UHID.  Works perfect now.  I am not sure why it only works this way for me.  Maybe my computer?  Before everytime I tried to change anything in M2 config, it would automatically put in Joystick #2 up.  Weird how the littlest change makes a difference.  

--- End quote ---
Just for interest sake, is there some reason you can't use the U-HID for all controls? The U-HID emulates keyboard, joystick and mouse.

Navigation

[0] Message Index

[*] Previous page

Go to full version