Main > Main Forum
Wiring diagram for a thrustmaster NASCAR pro digital wheel
Vigo:
Awesome!! You rock! I will get to work on this tonight! I think i can figure out the wiring for the pedals to the Jp1 board for you. Thanks!
boardjunkie:
Right ahn.....
Vigo:
Finally got the wheel working....mostly. For some reason, button 3 on the steering wheel will only register as pressed when button 4 is held down. There must be something funky with the grounds, but I am not gonna spend any more time on this one. I'm calling it good. I will just make button 3 and 4 at the same time as a quit hotkey.
boardjunkie, here is where I traced the pedals to. Keep in mind that my wheel was just resoldered, so there is a chance something is effed up by me, but I think this should work fine for yours. Also, I think it is a Windows 7 generic driver issue, but I had to reverse the polarity on the gas pedal pot. I tried a couple games and they got confused with pedal polarity, so I just reversed it.
gas pot pole 1 = Red wire on JP3
gas pot pole 2 = Purple wire on JP2
(Gas pot was originally soldered to lead 3 and 2 respectively.
brake pot 2 = Yellow wire on JP3
brake pot 3 = White wire on JP1
Navigation
[0] Message Index
[*] Previous page
Go to full version