Main > Main Forum

Using a PACLED to control cathode tubes?

<< < (3/3)

TheShaner:
I would assume that you could because of the nature of the strip, but thanks for asking Neph!  I am no electrician,so please someone chime in!  I was thinking of doing some LED rope light under the cab for the glow. Pulsing that with the LED marquee, buttons and joysticks would be sick!

rockyrocket:
Hi, this sort of thing is commonly done with pincabs (LED strips) although usually with a ledwiz but that is not an issue.
As an example check this out...
http://www.hyperspin-fe.com/forum/showthread.php?13146-Big-Bang-Pin-46-30-15-6-LED-Widebody-%28custom-artwork-bezel-less-deep-playfield%29/page61&highlight=bang
The same three outputs are controlling both an RGB flipper button x2 and then also a 12v RGB strip, i myself have a matching set up with four 5v button LED`s and a 12V RGB strip all from 3 ledwiz outputs.
Hope this helps.

Navigation

[0] Message Index

[*] Previous page

Go to full version