Main > Main Forum

Damaged PCB?

<< < (4/4)

EvilGreenDevil:
Quick update:

Replacement Lono2 came in (with cookies) and it works perfectly. My only concern is I'm scared to fry the board again. At this point i just have the push buttons connected to the Lono2 and not the LEDs. what I was planning on doing was have the LEDs and signals run on separate circuits, completely ignoring the EZ-off option.  So:

Microswitches signal/ground ----> Lono2
12v LED lights power/ground----> PC Power supply

both are separate so I don't see there being an issue but figured I would ask just for some reassurance.

thanks

PL1:

You should be fine as long as you don't short the 12v to the Lono2. . . but you already know that part.  >:D


Scott

Navigation

[0] Message Index

[*] Previous page

Go to full version