Software Support > Automated Projects

How does this sound for a Automated Joystick Setup?(Updated)

<< < (2/3) > >>

EightBySix:

--- Quote from: darthpaul on May 14, 2012, 07:11:17 pm ---You will have to enlarge the holes in the servo horn

--- End quote ---

... And don't forget to lubricate the flanged trunion inverter

darthpaul:
I was trying not to throw too much at him at one time.

ArcadeSeeker962:
Thank you guys for the tips. I'll look for cheaper #4 machine screws. As for the flanged trunion inverter, I don't know what part that is. Like what darthpaul said, I'd like to assemble the automated part of the control panel step-by-step, since I'm new to this concept. However, lubricating parts is no problem for me, I know how to do stuff like that(unless if it's more difficult than I think it is...).

darthpaul:
Just playing with you  ;D

drventure:
For screws, buy a big ol' mega pack assortment. You might spend 20$ now, but you'll have enough screws and nuts for plenty of projects on into the future, and you'll spend a LOT less money.

I bought brass screws/nuts piecemeal and spent way too much.

Navigation

[0] Message Index

[#] Next page

[*] Previous page