Main > Main Forum
Fake coin door
matsadona:
--- Quote from: Unstupid on May 02, 2012, 08:51:44 pm ---For what it would cost to do something like that you could buy a real door...
--- End quote ---
Isn't this forum about building things just because you can? ;D
JayB:
Put a kids toilet seat on instead ;D
Mysterioii:
--- Quote from: Unstupid on May 02, 2012, 08:51:44 pm ---For what it would cost to do something like that you could buy a real door... Mikesarcade has a full 2 slot door with mech and everything for $65.
--- End quote ---
Not seeing it on their site? I see mechs but not full doors.... out of stock maybe...
Unstupid:
--- Quote from: Mysterioii on May 03, 2012, 08:09:14 am ---
--- Quote from: Unstupid on May 02, 2012, 08:51:44 pm ---For what it would cost to do something like that you could buy a real door... Mikesarcade has a full 2 slot door with mech and everything for $65.
--- End quote ---
Not seeing it on their site? I see mechs but not full doors.... out of stock maybe...
--- End quote ---
Sorry... It was from twistedquarter.com and it was $69.99. But they have others cheaper... ;)
Le Chuck:
If you're working 1:1 scale you could use 1/8th inch project board and route the raised outline of say an Atari over under then round all edges and glue that down to a template. The coin drops and returns could be carved very easily in the same manner. If you're working smaller then there are a lot of options, Bender uses styrene and I favor aluminum for mines.
Navigation
[0] Message Index
[*] Previous page
Go to full version