Main > Main Forum

install a 4-pin annode RGB to a button??

(1/1)

gstav:
Hi!

I have the Seimitsu PS-14-KN and bout some annode 4 pins RGB leds to light them up!
I've seen guides of installing pre-made RGB boards sutch as UILA and ARCEYE, but is there any instructions made
for my type of install?

Any smart way of doing this? Guess I have to drill a hole in the base somewere..  ::)

Cheers! :cheers:

BobA:
You can bend the pins of your LED out so you can install it the same way as the UILA board.   Holes will have to be in the same place and you would have to solder wires to all the pins (4).

gstav:
Thanks mate!  ;D
Found a gudie installing the UIila board

Do you think is enough with one RGB led or do i need 2 / button?

This is the type of RGB's that I have
http://www.ebay.com/itm/20-pcs-5mm-4PIN-Common-Anode-RED-GREEN-BLUE-RGB-LED-R-/190565595706?pt=LH_DefaultDomain_0&hash=item2c5e983a3a]http://www.ebay.com/itm/20-pcs-5mm-4PIN-Common-Anode-RED-GREEN-BLUE-RGB-LED-R-/190565595706?pt=LH_DefaultDomain_0&hash=item2c5e983a3a]http://www.ebay.com/itm/20-pcs-5mm-4PIN-Common-Anode-RED-GREEN-BLUE-RGB-LED-R-/190565595706?pt=LH_DefaultDomain_0&hash=item2c5e983a3a


Thanks for the help!  :applaud:

BobA:
No real way to tell until you get your LEDs and try them.  :dunno

gstav:
*lol* true! :burgerking:

Navigation

[0] Message Index

Go to full version