Main > Main Forum
Small Problem - Response time? Hardware prob? Software prob?
topdawgg:
--- Quote from: BobA on March 07, 2012, 02:08:55 pm ---No the dotted position lines are split. The small cone goes in from the bottom and the pipe with the flange (short or long) goes in from the top. You only have to work with the bottom of your joystick to correct it.\
--- End quote ---
lolol think i understand. I will try it out soon. You guys rock.
Hoopz:
Be careful when you pop the e-clip off. It'll fly anywhere if you don't have it covered with a towel or have it in a pair of pliers. FYI...
RandyT:
--- Quote from: Hoopz on March 07, 2012, 02:23:48 pm ---Be careful when you pop the e-clip off. It'll fly anywhere if you don't have it covered with a towel or have it in a pair of pliers. FYI...
--- End quote ---
I might as well use this opportunity to provide an "e-clip" tip :)
What I do is use a small, flat screwdriver which fits into the gap between the clip and the shaft. Hold your thumb on the outside of the clip where the gap is, and your index finger on the other side, insert the screwdriver into the gap and carefully twist. If the clip wants to fly, it will do so in the direction where your thumb is placed, so it doesn't go anywhere. I haven't lost a clip in years using this method.
topdawgg:
THANK YOU EVERYONE IN THIS THREAD!!!!!
Changing the controls the way they are supposed to be.... = throwing fireballs like a champ!!!!
You guys are awesome.
Navigation
[0] Message Index
[*] Previous page
Go to full version