Main > Main Forum
Fixing t-molding slot
BobA:
+1 on hot glue if the slot is oversized or can be made oversized to center the t molding,
GregD:
Hmmm. I think i will try the glue method. Thanks.
darthpaul:
And I thought I was the only one to use hot glue.
leapinlew:
If you go with the hot glue, how stuck on is it going to be if you need to replace it?
dandare:
if its for a slot that's a bit too big, i found 'blu tac' to be a great non-permanent solution.
roll into long thin sausages, and push the t-mold in (ooh-er!).
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version