Main > Main Forum
Locking a showcase CP?
pinballwizard79:
I have a showcase with a custom built CP but no locks :'(
My fear of installing locks similar to my old CP is if I mismeasure with the paddlebit/hole saw for the cam (too high or too low) I will be eff'd.
Does anyone have some jedi suggestions for closing up a showcase CP?
Thanks
PW79
BobA:
You can use panel latches if you can access them via your coin door.
yaksplat:
Electromagnet with hidden switch?
A small coil with a plunger being used as a lock pin?
just some thoughts off the top of my head.
Vigo:
--- Quote from: BobA on February 05, 2012, 10:32:25 pm ---You can use panel latches if you can access them via your coin door.
--- End quote ---
+1 :cheers:
Le Chuck:
Bondo carriage bolts into the underside of the top of the CP. Drill through the bottom of CP box and bolt from the bottom. Pics may give us a better idea of a legitamite solution.
If you wanna get really crazy you could install a servo to run a bolting arm from the inside then use an blue tooth presentaton clicker to trigger a AHK script calling the servo into the open or closed position. ;D
Navigation
[0] Message Index
[#] Next page
Go to full version