Main > Main Forum
Which Pot do I get?
HanoiBoi:
Hey punks, get off the grass.
Drugs are for thugs.
Drnick:
:applaud: :applaud: @ all the jokers.
mamefreak2:
--- Quote from: BobA on January 11, 2012, 07:06:44 pm ---If you are going to extend the existing volume control that comes with the speaker set you will have to take apart the volume control to find out what the value is. If you take it apart and measure from outside tab to outside tab you will have the resistance of the pot required to replace it. Or you could relocate the volume control that comes with the speakers to someplace convenient for you to access it.
--- End quote ---
Okay, I opened up the volume control and I saw a connector inside. There wasn't too much writing on it. It said:
CSW
PCB -1730
And then a little further down it said 02 HB.
Richard_Nixon:
Is it a 3 pin connector? Measure the resistance on the 2 outside pins. The middle pin should be the wiper.the highest resistance you can measure is the value youre looking for. The values are usually in the kohms. Standard values are 1 k, 5 k and 10k.
mamefreak2:
You can view the images of the inside of the volume container here:
http://imageshack.us/g/825/img7206n.jpg/
Sorry, I tried to get it clearer but that was the best I could do. There are the left and right speaker wires each have three small wires that hook into the little circuit board. There is no indication of any numbers other than the ones I provided above. Its just three small wires on each side going into a white plastic piece connected to this brown circuit board.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version