Software Support > GroovyMAME
Monitor presets
Torkyo:
It works! Thank you very much! 1.000 was good, I didn't need to increase more the value.
thanks again!
eewoke:
--- Quote from: Torkyo on July 06, 2021, 06:48:17 pm ---It works! Thank you very much! 1.000 was good, I didn't need to increase more the value.
thanks again!
--- End quote ---
It works for me too. However, how should my vertical.ini looks like? Now I cannot use pstar, but should use custom. Can you please help me out?
Thanks for the great work!
Calamity:
--- Quote from: Torkyo on July 06, 2021, 06:48:17 pm ---It works! Thank you very much! 1.000 was good, I didn't need to increase more the value.
thanks again!
--- End quote ---
If 1.000 is still not enough in some circumstances, increase it on 1 by 1 steps (1.00, 2.00, 3.00, etc) or 0.5. The upper reasonable limit is 4.70, that's the standard value for NTSC.
Calamity:
--- Quote from: eewoke on July 07, 2021, 01:09:14 pm ---It works for me too. However, how should my vertical.ini looks like? Now I cannot use pstar, but should use custom. Can you please help me out?
Thanks for the great work!
--- End quote ---
Copy the "monitor custom" line plus the crt_range ones.
eewoke:
--- Quote from: Calamity on July 07, 2021, 01:18:28 pm ---
--- Quote from: eewoke on July 07, 2021, 01:09:14 pm ---It works for me too. However, how should my vertical.ini looks like? Now I cannot use pstar, but should use custom. Can you please help me out?
Thanks for the great work!
--- End quote ---
Copy the "monitor custom" line plus the crt_range ones.
--- End quote ---
Thanks! I did, but some resolutions like dkong are out of sync. Arcade-15-25-31 works but I don’t know if this is the most optimal setting for my pstar.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version