Main > Main Forum

Control Panel method - simple

<< < (2/3) > >>

Blanka:
I have the same corners, as they are dictated by the smallest CNC machine bit, 18mm. The only difference is that I route deeper, so the washers are under the CP.

Martijn:
Thnx, i was just arrived at this part, howto flush sink the bolts with the joystick plate.

Ond:
This weekend I got around to doing two more CP units for my mates cocktail cab.  He's been waiting quite a while for these, I finally found time to work on them :).




Here they are after primer coat in the spray tent. 



Still to do, sand back the primer and spray with a couple of coats of gloss black.

GregD:
What is the plate that you are using to cover the panels made out of?

Malenko:
looks amazing! I do kinda like the idea of routing a little deeper so the dust washers dont hide that awesome finish.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version