Main > Main Forum

Adding a volume control to some speakers

<< < (5/5)

venom:
cheers Drnick. Have loads of crimps from my arcade cab restore.

just for my clarity.

Cut Both grounds that currently go to the two speakers lets call them A and B

Then take one of these wires to pin 1 (A)
Insulate the other wires of e.g in terminal block (B) i.e no need to connet to the l-pad.

Then on the other pin 1 attach two wires and wire then  speaker 1 ground and speaker 2 ground.
So only using 3 wires in total.
I looked at speakers today and both have 8 ohm 10 watt wrote on them so  15 watt is more than plenty may even see if they make 10 watt ones.

Navigation

[0] Message Index

[*] Previous page

Go to full version