Main > Main Forum

Control panel (plexi) edge scratching the heck out of our wrists

(1/2) > >>

emb:
My wife and I keep scratching the heck out of our wrists because of the acrylic sitting above the control panel. Does anyone know of any ways to fix this problem?

I have searched the internet for some offset tmolding or lipped tmolding to cover the acrylic edge, but was not able to find anything that would fit because of where my slot is cut.

The control panel is 3/4" thick
The slot is cut through the middle of the control panel wood (3/8")
The plexi glass is 1/16" thick

I currently have 3/4" tmolding installed on the panel.

Nephasth:
Your t-molding slot should have been 1/16" closer to the top of the panel. Bevelling the edge of the plexi with some sand paper should help.

Sjaak:
Can you remove the plexi?

emb:

--- Quote from: Sjaak on September 11, 2011, 02:13:01 pm ---Can you remove the plexi?

--- End quote ---
I could but I would like to protect the finish of the wood.

Blanka:
Get a polish wheel for your drill (probably an english word for it, I dunno, so I''m describing it). They are made of a +- 6cm thick stack of cotton cloth sheets, and you apply some polish paste on them. Go along the edge, and it will be perfect rounded in a few minutes.

Navigation

[0] Message Index

[#] Next page

Go to full version