Main > Main Forum
GGG Trackball not moving/spinning
mordelack:
Please consider me a rookie. :)
I just mounted the trackball (Electric ICE-T™ Deluxe RGB Arcade Trackball V2.5 with the USB connection) and when I try to use it it does not spin. I loosened the nuts holding it in place and then it spins. If I leave it this way should I be worried about the nuts eventually falling off and the trackball falling? Its seems that if you tighten the nuts the trackball enclosure has pressure applied to it and then the ball can no longer spin.
Any thoughts?
Many thanks
BobA:
How did you mount the trackball in your CP? Some pics might help. The mounting screws should not compress the trackball housing and make it interfere with the ball rotation.
Smeghead:
That is an epically nice cabinet dude!
mordelack:
--- Quote from: BobA on September 08, 2011, 01:04:18 pm ---How did you mount the trackball in your CP? Some pics might help. The mounting screws should not compress the trackball housing and make it interfere with the ball rotation.
--- End quote ---
Thanks for responding BobA. I mounted the trackball with the 3" GGG trackball mounting kit. Here are two pics of the work in progress
TopJimmyCooks:
I was able to tighten the mount bolts through my happ trackball enough to make it hit an occasional rough spot. I think my routing left a less than perfectly flat plane under the CP, so it twisted the housing when everything was cranked down. I spaced the top of the housing from the bottom of the cp with some rubber washers. then, I used internal toothed lock washers (instead of split ring lock washers) and just snugged up the bolts. holding fine so far.
Navigation
[0] Message Index
[#] Next page
Go to full version