Main > Main Forum

12 volt coin mech jpac how do i connect it?

<< < (3/3)

lostinarcade:
to coin mech i have is.
Wei-Ya Coin selector HI-07CS.
http://www.weiya.com.tw/products_detail.asp?le=english&fid=75&pid=90&tCatName=Front%20Inserting%20Type

Grey - counter +/-
Red - DC +12V
White - Coin Signal
Black - Ground
Grey - counter +/-

AndyWarne:
We sell those and they will work fine.

Andy

lostinarcade:

--- Quote from: AndyWarne on September 08, 2011, 02:41:44 pm ---We sell those and they will work fine.

Andy

--- End quote ---

thats good to know
thanks

southpaw13:
So how does it get wired?  I had problems.  How do you hook it up to a Ipac?  Do you need a zener diode?

Thanks,
Southpaw

BobA:
Set the NO (normally open) jumper and connect the coin output to the input of your ipac or other controller.

Navigation

[0] Message Index

[*] Previous page

Go to full version