Main > Main Forum

Please critique my control layout before I start drilling.

<< < (3/4) > >>

upper2bits:

--- Quote from: jimmy2x2x on August 01, 2011, 06:17:20 pm ---Is the CP so wide to accommodate the cab, or will the CP overhang the cab?

--- End quote ---

What the full cab looks like: 

upper2bits:
Playing around with some graphics. :-)

eds1275:

--- Quote from: fallacy on August 01, 2011, 02:51:19 am ---id say Heineken suck.  >:D

--- End quote ---
Heineken is my friend!

Gray_Area:
It looks fine....though the following is running in my mind: you had the ability to make nice curves, yet didn't make the front 'corners' rounded. At least round the edges off. Thread title: "...before I start cutting..."

upper2bits:

--- Quote from: Gray_Area on August 03, 2011, 04:33:14 pm ---It looks fine....though the following is running in my mind: you had the ability to make nice curves, yet didn't make the front 'corners' rounded. At least round the edges off. Thread title: "...before I start cutting..."

--- End quote ---

I tried it with rounded corners but it looked odd to me.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version