Main > Main Forum

Cocktail LCD bezel help?

(1/1)

Jefferson:
Hey guys,  I've started building a cocktail cabinet out of an arcade depot kit (its gorgeous) and I'm about to order a consolidated last bunch of supplies, whats stopping me is my uncertainty with the monitor bezel.  I've got a 19" Polyview LCD with a nice viewing angle, has anyone used one of these bezels..?
http://www.twistedquarter.com/index.php?main_page=product_info&cPath=52&products_id=845

Also, what would I use to cut the outside edges of the bezel to fit?

I've searched around the forums but havent heard of anyone using this product...

BobA:
If the bezel is flat plastic you could use a flat edge and a router with a trim bit to cut it down to size.  Same setup works will for plexi or lexan.

Smeghead:
I made my own out of 1" * 1" rubber 90 degree angle stripping, looks great and is soft on the LCD if you ever dropped the lid
What I meant is, L shaped 1*1 rubber stripping, I think it was meant for some door part or something (from Home Depot)

Navigation

[0] Message Index

Go to full version