Main > Main Forum
Spinner Design Question
PL1:
--- Quote from: D_Harris on June 24, 2014, 07:31:15 pm ---I did some searching and assume that this is the place to get the controller. http://northamerica.emukade.com/product-category/encoders/
And that what I need is one of the following, correct?:
1) "DIY KADE miniArcade kit complete"
2) "DIY KADE miniArcade kit no AVR"
3) "KADE miniArcade- Red, White, and Blue"
--- End quote ---
Options 1 and 3 have the required "brain", a Minimus AVR -- either an at90usb162 or an atmega32u2 will work with all the miniArcade series of firmwares.
There are also other places like here to get a Minimus AVR if your budget is tight.
--- Quote from: D_Harris on June 24, 2014, 07:31:15 pm ---I'm just not sure where to get the "new KADE miniArcade firmware" you mentioned.
I can solder, but not much more than that. Anything involving software requires step-by-step instructions, which I've found to be rare.
--- End quote ---
The firmwares are in the Loader software.
The instructions are spelled out in the QuickStart guide here and in the KADE Loader software. ;D
Scott
D_Harris:
I probably should have bought more MiniPACs when they were $29. (Not including harness). ;D
The MiniPAC is simpler/easier to install. At the time I considered them overkill for the kind of control panel I mentioned above and decided to save them for a different project.
Thanks.
Darren Harris
Staten Island< New York.
Navigation
[0] Message Index
[*] Previous page
Go to full version