Main > Main Forum
Custom Monitor Bezel
(1/1)
Woodshop Flunky:
I'm going to go way out here...
Does anyone have any experience with vacuum forming? I have several sheets of ABS plastic with haircell texture on one side. I would like to produce a monitor bezel for the CRT PC monitor I decased.
I've read about it, and I have a process in my head that I think will work. However, it certainly seems like a LOT to bite off.
Anyone tackle something like this before?
mrclean:
phineas foo on the KLOV forums does this : http://forums.arcade-museum.com/showthread.php?t=151068, I would contact him.
HaRuMaN:
Or you could just do this:
2 dolla bezel
Woodshop Flunky:
--- Quote from: mrclean on June 23, 2011, 02:46:35 pm ---phineas foo on the KLOV forums does this : http://forums.arcade-museum.com/showthread.php?t=151068, I would contact him.
--- End quote ---
I think I've run across this guy before, but at this point in my build, I don't think I can justify the expense (if I can do something myself).
--- Quote from: HarumaN on June 23, 2011, 02:48:51 pm ---Or you could just do this:
2 dolla bezel
--- End quote ---
Thanks. If the ABS doesn't pan out... I'll likely end up with something like this. :)
Navigation
[0] Message Index
Go to full version