Main > Main Forum
Ok Baby candy cab CPS2 question (about stereo sound)
Malenko:
--- Quote from: amendonz on May 13, 2011, 12:58:54 am ---hmm.not sure i follow, i am using the jamma connector now, but its only running on one speaker, i'd rather be running stereo from the A board, but when i plug it in nothing changes...
the non working speaker isn't broken, its just not receiving any signal, also the cps2 board is outputting stereo, i checked on my stereo.
so are you saying what i have it plugged into is not an amp then? (The cps2 audio output via rca cables)
so i have to find a switch to change it from mono to stereo? hmm.. my friend was saying some ok baby have a switch next to the volume control for that, in mine its just a covered hole.
:timebomb: looking more likely shes going full time mono...
--- End quote ---
How are you hooking the A board into your stereo? Jamma is mono. if you use the RCA outs from the A board, you feed them into an amplifier and then use that to power the speakers.
amendonz:
@emphatic,
so, from that manual, i need to pull off the wires from the mono output and move them onto the stereo amp output?
ok, seems not too hard...
emphatic:
--- Quote from: amendonz on May 14, 2011, 06:47:18 pm ---@emphatic,
so, from that manual, i need to pull off the wires from the mono output and move them onto the stereo amp output?
ok, seems not too hard...
--- End quote ---
If possible, take a picture of your amplifier and it will be easier to help you.
amendonz:
best photo i could take, hope its not too fuzzy.
amendonz:
thats with the stereo rca not connected (obviously)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version