Main > Main Forum

Anyone here ever make a DDR machine? Need help with roms...

<< < (5/7) > >>

drventure:
@DataWest

Mine had the same issue, till I found online a "secret code" that alters the dance pad's logic.

Check the page here

http://www.stepmania.com/wiki/Dance_Pads

Most pads have a code (something like hold down select for 5 seconds, then up down up, or some such) that will put the pad into a mode where multiple simultaneous presses will register.

DataWest:
http://www.stepmania.com/wiki/Dance_Pad_Code

Thanks! I'm going to try that for sure...I don't have much hope for it though as the PS3 pad doesn't have an adaptor, it's just USB out.

I post here later if it does work. The PS3 pad is only $40 at gamestop with the ps3 game too. For a flat pad it's pretty darn good.

drventure:
There was a couple of comments about using XBCD or XPadder to compensate for the axis problems too. Might also be something to look into.

DataWest:

--- Quote from: drventure on April 30, 2011, 02:40:09 pm ---There was a couple of comments about using XBCD or XPadder to compensate for the axis problems too. Might also be something to look into.

--- End quote ---

Tried everything last night...came to the realization (and the stepmania forums confirmed this) that no one knew how to make the PS3 pads work with a PC. I wish I had gotten an xbox 360 one  :banghead: you can make those work with the programs you listed.

drventure:
Here's what I picked up. Sucks about the PS3 pads.

http://forum.arcadecontrols.com/index.php?topic=88515.msg1040134#msg1040134

These work ok, once you enter the code.

But I think those hard mats (like the cobalt flux) would work better.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version