Main > Main Forum
Wico reproduction shafts with 1.5" balltops!
shilmover:
--- Quote from: armi0024 on May 12, 2011, 12:00:40 am ---I need to talk to Wolfeel about his plans. I will probably be doing hollow Wico shafts soon.
However, on a VERY interesting side note. I took one of these ball tops and put it on a JLW Bat top shaft and it was 4 way heaven.... I know that JLW's are leafs, but it basically made a perfect Ms Pac/Galage replacement stick... I'll take pictures later.
--- End quote ---
Bryan,
I really need one hollow shaft with a red ball (need to put a button in it), and a green ball. For my MultiVector.
mrclean:
--- Quote from: D_Harris on May 12, 2011, 06:51:16 am ---
What do you use to clean yours?
Darren Harris
Staten Island, New York.
--- End quote ---
Hello fellow New Yorker! Simply put it in the end of your chuck of your drill.. and spin it, holding it with a magic eraser a dash of water or if it's really tough to get out use a sponge that has the green more abrasive backing (sorta like a light brillo pad) just hold it and spin / use your drill.
Like this :
jasonbar:
--- Quote from: armi0024 on May 12, 2011, 12:00:40 am ---I need to talk to Wolfeel about his plans. I will probably be doing hollow Wico shafts soon.
--- End quote ---
Hey Bryan-
See if you can lean on Wolfeel to sell just the threaded red balls--I'm dyin' for some!!!
Thanks,
-Jason
armi0024:
I need to see what's up, I may do a run of just ball tops
armi0024:
Bumping an old thread, we just started stocking these and they look GREAT!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version