Main > Main Forum
HELP: Trackball w/Optiwiz USB interface results in left/right not working
jroyal:
Awesome! Thanks Randy. When you say, send me your TB harness, are you referring to the white connectors with the red/back, green/yellow and blue/purple wires on them? I will be glad to order and send that to you. What address do I send it to?
Thanks a ton!
jroyal:
One more question, any suggestions to mount the trackball from the back of the wood? I have 5/8" MDF that already has a paper backgound and the plastic laminate installed on the top. I wanted to be able to install the trackball without having to remove all the buttons........ any ideas?
RandyT:
--- Quote from: jroyal on July 14, 2011, 05:07:50 pm ---Awesome! Thanks Randy. When you say, send me your TB harness, are you referring to the white connectors with the red/back, green/yellow and blue/purple wires on them? I will be glad to order and send that to you. What address do I send it to?
Thanks a ton!
--- End quote ---
Yes, that's the one. Place the order, drop a note in the comments at checkout and I'll contact you.
RandyT
jroyal:
Before I order, any suggestions to mount the trackball from the back of the wood? I have 5/8" MDF that already has a paper backgound and the plastic laminate installed on the top. I wanted to be able to install the trackball without having to remove all the buttons........ any ideas?
If I need some sort of mount, I want to include it with the order! Thanks again!
RandyT:
--- Quote from: jroyal on July 15, 2011, 09:43:22 am ---Before I order, any suggestions to mount the trackball from the back of the wood? I have 5/8" MDF that already has a paper backgound and the plastic laminate installed on the top. I wanted to be able to install the trackball without having to remove all the buttons........ any ideas?
If I need some sort of mount, I want to include it with the order! Thanks again!
--- End quote ---
Trackballs are always a bit problematic to install. The more cleanly one desires the integration into a panel to be, the more effort is required. The simplest is, of course, the standard trackball mounting plate, which we carry. This will give a large black square surround, which some don't mind, but others do. This can be remedied by routing a pocket in the top of the panel the exact depth of the plate and "flush mounting" it. One would then put an overly on the entire panel, leaving a hole to accommodate the lip of the ball housing. The alternative is to route a pocket in the underside of the panel the size of the housing, leaving about 1/4" of material at the top. One would then make a very clean hole for the lip of the ball housing, and perhaps route a beveled edge to make a clean transition. The housing can be mounted to the panel with the use of carriage bolts (not as clean) or with "L brackets" from below.
Hope this clears it up a little for you :)
RandyT
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version