Main > Main Forum

Spinner/joystick question

(1/1)

ZERO:
I may have ordered the wrong spiner, but I'm not sure. I ordered a quad controller from north coast custom I then ordered my spiner from Ultimate arcade, it was there only one so I was thinning they where all the same. But when I tried to install it the pin does not come all the way up. Do I need to drill it?  Did I buy the wrong spiner? If you need more info let me know.



And about joysticks  I have 4 old joysticks from an arcade, I could use them but I would have to drill the 4 bolts out. Or is there joysticks that don't require me to dill?

BobA:
Don't know which spinner you ordered as the site for ultimate arcade did not come up.   This is the spinner that is referenced by NC Custom.

Tornado

ZERO:
http://www.ultimarc.com/JShopServer/section.php?xSec=10


looks like i got the wrong one thanks

Navigation

[0] Message Index

Go to full version