Main > Main Forum

Turbotwist2 dimensions?

<< < (2/3) > >>

robertsig:

--- Quote from: VanillaGorilla on February 10, 2011, 05:56:10 pm ---Ok, should I just keep guessing then?  :blowup:

--- End quote ---

Sure, if you like.  I only asked for the dimensions.

dfmaverick:

--- Quote from: VanillaGorilla on February 10, 2011, 04:33:59 pm ---Who would use it without the weight?
--- End quote ---

"If operation as a spinner is desired and a lightweight knob is to be used, it is strongly recommended that the optional Energy Storage Cylinder (ESC) is purchased."

"No ESC Required - The Energy Storage Cylinder is no longer required for prolonged spin when you use the TokenTop knob. Reduces the vertical footprint of the TurboTwist 2 to an amazing 1.5" below 3/4" wood panels with no spinner performance penalty!"

robertsig:
Thanks, I did see that on their site.... although that statement is worded in a way that makes me think it would *not* be a mere 1.5" below a 3/4" wood panel without the Token knob.  I don't see how, so I'll have to buy one and take a chance.

HanoiBoi:
Based on replies, sounds like its 2 1/4" without the weight and about 3 1/8" with.

I think your statement about the TokenTop knob is correct.  The point there, I believe, is that the TokenTop has some weight to it that would eliminate the need for the ESC.

Do you know your depth restriction?

If you've got about 3 1/2", then you're good either way.

robertsig:
For a small bartop I was thinking of buying, I believe I only have 2 inches below the panel.  I'll have to verify.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version