Main > Main Forum

Help hacking a Roadblasters CP

(1/2) > >>

wp34:
I picked up a RoadBlasters CP off eBay.  It is one of my "grails" and I've not been able to find a satisfactory way to play it in MAME.  I also purchased an Opti-Wiz from GGG so I can connect it to my PC.   I'm looking for some advice for hooking this up from someone who has done it and/or is smarter than me.

Here are my assumptions -

Buttons -
Large Green Wire - Ground for buttons
Large Black Wires - Trigger and Special Weapons buttons

Optical Hook-up
Red = 5v power
Black = Ground
Blue=?
Purple=?

I'm assuming that the Blue or Purple are for the X-axis.

Any guidance or suggestions would be appreciated.  I've searched and not been able to find any specific information.

wp34:
I found this by accident -

http://www.thisoldgame.com/products/usb-adaptor-for-atari-yoke-controller

Anybody have experience with this adapter?

bkenobi:
That yoke adapter cable is not what you want.  That is for a Star Wars controller (maybe others too).  What you have is a standard Atari steering wheel board.  I don't remember which is which, but there's power, ground and a signal wire.  There should be a writeup here about hacking a pole position or some other Atari steering wheel.

huygens:
The blue and purple wires from the optic board are the quadrature signals. They should be hooked up to Xa and Xb on the opti-wiz (you need both connected). If the mouse moves in the wrong direction just reverse them.

wp34:

--- Quote from: bkenobi on December 14, 2010, 04:04:26 pm ---That yoke adapter cable is not what you want.  That is for a Star Wars controller (maybe others too).  What you have is a standard Atari steering wheel board.  I don't remember which is which, but there's power, ground and a signal wire.  There should be a writeup here about hacking a pole position or some other Atari steering wheel.

--- End quote ---

I thought the same thing but the item description specifically mentions RB and the molex connector looks about the same.  Not sure I'd want to risk $60 on it unless someone could tell me for sure it worked.  Thanks for the reply.

Navigation

[0] Message Index

[#] Next page

Go to full version