Main > Main Forum

button wiring

(1/2) > >>

cyberduck16:
hi
i have a cocktail table which i am in the process of turning to Mame. i have got to wiring the joy stick and buttons.
i rushed in to it and what i have done is instead of wiring the negatives in to each microswitch i have taken them individually from each switch in to a brass block with screw terminals on it. my question is will this still work? provided i wire one negative from the block to the usb board. i have ordered an ipac ve for this project and really hoping i dont have to rewire the buttons.

thanks in advance

severdhed:
should work fine.

cyberduck16:
thanks for the quick reply
just what i wanted to hear :)

thanks again

BobA:
That is if the negatives you are referring to are the common Ground.  It is all good if so wired.

cyberduck16:
Ok how would I be able to tell?

Navigation

[0] Message Index

[#] Next page

Go to full version