Main > Main Forum

Are Seimitsu Push Buttons NO and NC?

<< < (2/2)

saradilc:

--- Quote from: LeedsFan on October 20, 2010, 03:38:37 pm ---You could take a standard Happs push button and cut the plunger and casing down to what you need, then just glue the parts back together. For a one off button I'd be temped to give this a shot in your situation. A cherry microswitch and a cut down button with enough thread for the locking nut to grip would be about 30mm long (under the panel)

--- End quote ---

I may have to resort to this. I actually just miraculously found a local store that has momentary switches that are short enough and have NO and NC that highly resemble arcade buttons. I'm going to check it out in person and if I like what I see I will try one of those out. Unfortunately they are 24mm and not 30mm like the Seimitsu ones I ordered, however it's not a huge deal!

As for leaf buttons I'd rather avoid using one.

Another quick question: If I get a switch that has all 3: NO, NC and GND, am I able to hook up two seperate functions to the NO and NC parts of it simultaneously, or will they interfere with eachother?

Thanks for all the replies guys!

Navigation

[0] Message Index

[*] Previous page

Go to full version