Main > Main Forum

Looking for mountable USB port

<< < (2/2)

saint:

--- Quote from: drventure on October 12, 2010, 07:25:23 am ---http://www.lizardlick.com/Neutrik-NAUSB-W-B-AB-USB-Feed-Through-Black_p_222.html

Wish I'd seen this back when I was looking....

The technique I used was to buy a cheap USB extension cable, cut a hole that matched it's size and just epoxy it into place. Works great, doesn't look too bad, and it is cheaper (though not by much)

--- End quote ---

These are what I'm recommending in the second edition of Project Arcade. Arcadeshop.de carries these as well. The A/B is reversible so you can have whichever connector you want facing out. An A/B cable to your computer's USB port and you have a nicely mounted A connector sitting in the front of your panel or wherever you mount it.

ahofle:
I have the neutrik connectors as well.  The best thing about it is you only need to drill a single hole for a perfectly clean mount.  Most other solutions require you to route out a square shaped hole.

Navigation

[0] Message Index

[*] Previous page

Go to full version