Main > Main Forum
How to poewr the light bulb on my Happ Track Ball?
Hoopz:
--- Quote from: bkenobi on September 03, 2010, 11:18:48 am ---
--- Quote from: shateredsoul on September 03, 2010, 02:32:42 am ---the light bulb isalready attached under the trackball, it's not connected to a power source as far as I can tell
--- End quote ---
See, there's the problem. You will need to connect the light to power to get anything visible out.
--- End quote ---
:laugh2:
FrizzleFried:
These guys are just foolin' with ya...
Run a wire from one of the "hard drive" molex connectors from your power supply to the lamp... you want yellow and black I do believe (12v).
shateredsoul:
--- Quote from: FrizzleFried on September 03, 2010, 12:02:40 pm ---These guys are just foolin' with ya...
Run a wire from one of the "hard drive" molex connectors from your power supply to the lamp... you want yellow and black I do believe (12v).
--- End quote ---
Thanks! I guess I was just looking for a way to avoid opening up my pc.
:angry: @ the rest of you!
give a guy a break! Don't have to bust my balls, eesh! ha ha ha ok :P
atomikbohm:
--- Quote from: shateredsoul on September 03, 2010, 03:34:30 pm ---
Don't have to bust my balls, eesh! ha ha ha ok :P
--- End quote ---
How much power does that take? ???
Just kidding, it's all in fun, sorry :angel:
bkenobi:
:laugh2:
Navigation
[0] Message Index
[*] Previous page
Go to full version