Main > Main Forum

Ultimarc U360 Encoder Harness Wiring Question

(1/2) > >>

dawolv:
I just got my USB connects from Ultimarc, fast shipping from the UK to the US again   :applaud:
The wires on this harness look like they are 26AWG.

Has anyone used the .187 QDs on these 26AWGs?
If I have to use the 24-26 guage QDs wouldnt that be too small to connect to the button micro-switches?

severdhed:
USB connects?  are you talking about the button wire harness?  i don't know what guage they are for, but i used quick disconnects with the blue plastic sleeve on them, i picked them up at lowes. i just folded the end of the wire over a little and crimped them on, they have held up well. 

dawolv:
Here is a picture of the harness:


So by bending/looping/hooking the 26 gauge wire into the 16-22 gauge wire connector, you were able to use the .187 QDs for the Ultimarc USB Harness?





Ginsu Victim:
That's not USB.

ragnar:
Ya, you just have to fold the copper on top of itself 1 or 2 times.  Enough that when you crimp, there is more material for the wire connector to grab onto.

Navigation

[0] Message Index

[#] Next page

Go to full version