Main > Main Forum

Some general quesitons about first MAME cabinet setup

<< < (4/7) > >>

CheffoJeffo:

--- Quote from: cotmm68030 on September 03, 2010, 06:05:49 am ---Have you tried bypassing the JPac for the VGA? It's not required since the ArcadeVGA is already producing 15kHz.

--- End quote ---

The JPac isn't a scan converter and should not be bypassed.  :dizzy:

newmanfamilyvlogs:

--- Quote from: CheffoJeffo on September 03, 2010, 06:25:02 am ---
--- Quote from: cotmm68030 on September 03, 2010, 06:05:49 am ---Have you tried bypassing the JPac for the VGA? It's not required since the ArcadeVGA is already producing 15kHz.

--- End quote ---

The JPac isn't a scan converter and should not be bypassed.  :dizzy:

--- End quote ---

Then I must be thoroughly confused as to what the JPAC actually does for the video signal.  :(

Disregard me, I suppose.

Malenko:
rolling you say? have you tried adjusting the Vsync and other adjstable knobs? it took a bit of tweaking for me to get soft15 running on my 25k7197 just right.


cotnmm68030 the JPAC will prevent bad signals from reaching the monitor, protecting it from damage.

Umgar:
Adjustable knobs? Where would these be?  :dizzy: 

Sorry, tohl noob here...

M.Lanza:
On the back of the monitor pcb.

You can see them in the picture.


Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version