Main > Main Forum

How to program new MiniPac?

(1/2) > >>

Blanka:
I just installed a new minipac (the mini USB port UHID lookalike version), and it does not work with the WiniPac utility. I get an error "Failed to program device" error, after which the unit does not work any more until I replug it into the USB port. I also tried the U-config utility (as it looks like a UHID), but that one does not recognize the board at all. Do we need a new utility for the new MiniPAC?

Trap:
I had this same problem when we built my friend's cabinet.  We ended up just making the default settings work.  Are you using Vista by chance?  I was having all sorts of trouble trying to install both winIPAC and the U360 software on his cabinet running Vista. 

chill:
I had the same issue trying to use Win 7.
find an XP machine and it should be ok.


Blanka:
It is running on XP,
I'll see if I can hook it to a Mac.

Blanka:
MacIpac can program the new MiniPac, but not the shift function. :(
I see it works partly as the changes in non-shift buttons are uploaded, where the shift ones don't

The DOS application under XP works but gives a time-out error when choosing program.

Tried WiniPac again, after programming, you get an error, and the whole controlpanel goes "offline" until you reboot.

Navigation

[0] Message Index

[#] Next page

Go to full version